![]() ![]() in normal full load, the VDD voltage of the device must be lower than the over-voltage protection.Low level, also pulling down the total power consumption.Īll these contents can be summarized by the following list: Transformer structure, all the other secondary outputs and the auxiliary voltages are pulled down to a very In this condition the +5Vstb is regulated. +5Vstb output is connected to the feedback loop. Of Q3 can not provide enough voltage to maintain D12 conducted, so the 5V output is blocked, and the When the stand-by signal is present, the Vce Output is blocked by Q3, so +5Vstb regulation is neglected. The feedback loop is connected to 5V output by D12 to regulate 5V output. This function is very useful for achieving low stand-by total power consumption. Values for under-voltage and over-voltage protections. VIPer22A has a wide operating voltage range from 8V to 42V, respectively minimum and maximum (14.5V), and then the VIPer22A starts switching. At the startup converter, it will charge the VDD capacitor until it reaches VIPer startup level Post added at 21:06 - Previous post was at 19:41 -Īs any member of the VIPer family, VIPer22A has an integrated high voltage current source linked toĭrain pin. i have a power supply with same problem and give me few days i will give the answer. According to my paractical experience, problem will not because of the transeformer.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |